2004 Seat Leon

Front passenger door cannot be opened from inside the vehicle (6.2.3 (a))

Nearside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing cracking in tread (5.2.3 (d) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing cracking in tread (5.2.3 (d) (ii))

Front Suspension arm corroded but not seriously weakened both (5.3.3 (b) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security n\s and o\s sill jacking points (6.2.2 (d) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material to flexy hose (1.1.11 (c))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Nearside Front Macpherson strut top bush or bearing has excessive wear or free play (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush excessively worn Bottom arm rear bush (5.3.4 (a) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Suspension arm pin or bush excessively worn Bottom arm rear bush (5.3.4 (a) (i))

Exhaust in poor condition, centre and back box

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement Rear axle bush (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement Rear axle bush (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Exhaust mounting defective (6.1.2 (a))

Rear Exhaust mounting defective (6.1.2 (a))

Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Engine MIL inoperative or indicates a malfunction On (8.2.1.2 (h))

Rear Exhaust mounting defective (6.1.2 (a))

Centre exhaust bracket broken

Exhaust rear box corroded

Parking brake: efficiency below requirements (3.7.B.7)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

rear parking brake recording little or no effort both (3.7.B.6a)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

middle exhaust bracket broken

Front DISCS CORRODED

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front coil spring broken (2.4.C.1a)

Front DISCS CORRODED

Offside Rear passenger door cannot be opened from outside the vehicle (6.2.B.1c)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

engine management light on. airbag light on rear exhaust mounting broken centre exhaust mounting loose but still supported

Nearside Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

air bag lamp on (passengers air bag turned off)

middle exhaust mtgs corroded off exhaust

Offside Rear rear brake application uneven (3.7.B.2)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

both front and offside rear tyres wearing low

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Stop lamp not working (1.2.1b)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

both front and offside rear tyres wearing low

Parking brake: efficiency below requirements (3.7.B.7)

rear wiper blade worn out

Offside Headlamp not working on dipped beam (1.7.5a)