2007 Iveco Daily 35S12 Mwb

Exhaust has a minor leak of exhaust gases where back box joins to centre section (6.1.2 (a))

Nearside Rear brake backing plate is corroded

Offside Rear Position lamp incorrect colour headlamp casing has cracked (4.2.3 (a) (i))

Vehicles internal headlight adjuster altered to recheck lights ()

under vehicle has been heavily under sealed

under vehicle has had welding done to it ((all structurally solid))

Exhaust has a minor leak of exhaust gases where back box joins to centre section (6.1.2 (a))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear brake backing plate is corroded

Offside Rear Position lamp incorrect colour headlamp casing has cracked (4.2.3 (a) (i))

Vehicles internal headlight adjuster altered to recheck lights ()

under vehicle has been heavily under sealed

under vehicle has had welding done to it ((all structurally solid))

Front Brakes imbalanced across an axle 40 % (1.2.1 (b) (i))

Front Registration plate insecure (0.1 (a))

Nearside Front Inner Brake master cylinder/servo mounting prescribed area is excessively corroded wing and under bonnet (1.1.21 (e) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

2nd bonnet catch not working

Horn not working (7.7 (a) (ii))

Nearside Headlamp aim not tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

2nd bonnet catch not working

Windscreen washer provides insufficient washer liquid PRS (3.5 (a))

Front registration plate deteriorated but not likely to be misread (6.3.1d)

secondary bonnet catch not working

Central Exhaust has a major leak of exhaust gases (7.1.2)

Front front brake application uneven (3.7.B.2)

Nearside Front Subframe mounting prescribed area is excessively corroded mounting plate (2.4.A.3)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Subframe mounting prescribed area is excessively corroded mounting plate (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

secondary bonnet catch not working

secondary bonnet catch not working

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim too high (1.8)

secondary bonnet catch not working

Horn not working (1.6.2a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

engine warning light on

Exhaust has a major leak of exhaust gases (7.1.2)

nearside front tyre bald on outer edge

Offside Registration plate lamp not working (1.1.C.1d)

Offside front brake binding (3.7.B.1)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)