2012 Mazda 3

Exhaust heat shield loose

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Exhaust heat shield loose

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust emissions exceed default limit of 1.5m-1 (8.2.2.2 (b))

Exhaust on a vehicle fitted with a diesel particulate filter emits visible smoke of any colour (8.2.2.2 (d))

Nearside Front Position lamp light intensity significantly reduced led bulbs fitted (4.2.3 (a) (ii))

Offside Front Position lamp light intensity significantly reduced led bulb fitted (4.2.3 (a) (ii))

Offside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Front Lower Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust emissions exceed default limit of 1.5m-1 (8.2.2.2 (b))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive from engine (8.4.1 (a) (i))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre obviously under inflated (5.2.3 (l))

Oil leak, but not excessive from engine (8.4.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Central Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust emissions exceed default limit of 1.5m-1 (8.2.2.2 (b))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

rear tyres different size to fronts

Anti-roll bar has slight play in a ball joint both rear (2.4.G.2)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure on inner sidewall (4.1.D.1b)

Anti-roll bar has slight play in a ball joint both rear (2.4.G.2)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)