2010 Hyundai Iload

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge outer edge (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Steering system slightly rough lock to lock, both the strut top bearings are stiff (2.1.1 (a))

steering is heavy at with the engine at tickover

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge outer edge (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Steering system slightly rough lock to lock, both the strut top bearings are stiff (2.1.1 (a))

steering is heavy at with the engine at tickover

Central Prop shaft bearing has slight play mounting bush is very weak (6.1.7 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear reflector defective or damaged by more than 50% of the reflecting surface (4.8.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Central Prop shaft bearing has slight play mounting bush is very weak (6.1.7 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Brake cable insecure (1.1.15 (c))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Brake pipe excessively corroded both front to rear (1.1.11 (c))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Nearside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Offside Front Position lamp not working (4.2.1 (a))

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside rear brake binding (3.7.B.1)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

nsf tyre cracking on outer edge and wall

osf tyre wearing on inside edge