2001 Fiat Motor Caravan

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch holed (5.3.6 (a) (i))

Front Brake pipe corroded, covered in grease or other material n/s and o/s (1.1.11 (c))

Nearside All outline marker lamps not working (4.2.1 (a) (ii))

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner wheel arch holed (6.2.2 (d) (i))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

exhaust corroded (starting to peel )

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

exhaust corroded (starting to peel )

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

both rear tyres wearing uneven and low on edges

Exhaust has a minor leak of exhaust gases centre silencer outer skin is deteriorating (7.1.2)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive out rigger area's (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch area's (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive out rigger area's (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch area's (2.4.A.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

centre section exhaust mounting is deteriorating

offside front top out line marker is inoperative

Battery insecure (1.9.1)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

battery loose

battery terminal loose

exhaust corroded

power steering pipes corroding

end caps missing rear bumper.

hoses under fuel tank need sercuring.[water hoses].

slight wheel bearing osr/nsr.

spare wheel mechanism corroded.