2001 Mercedes Unknown

Driver's seat with a defective structure floor area etc corroded resulting in movement of seat base etc. (6.2.5 (a) (i))

Nearside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Brake hose excessively stretched (1.1.12 (b) (ii))

Nearside Rear Suspension levelling valve damaged or deteriorated and function affected (5.3.5 (b) (i))

Offside Front Brake master cylinder/servo mounting prescribed area is inadequately repaired (1.1.21 (e) (i))

Offside Front Floor excessively deteriorated drivers footwell area (6.2.4 (a) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced area behind drivers seat area (6.1.1 (c) (i))

Offside Rear Body mounting fixings insecure (6.2.2 (c) (i))

Rear Suspension pipe leaking (5.3.5 (c))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Entrance/exit step in a deteriorated condition step area underneath corroded on mounting points not yet resulting in excessive movement (9.7 (a) (i))

Nearside Rear Fluid leak, but not excessive inner hub seal (8.4.1 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive water leak (8.4.1 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear boot area structure excessively corroded also boot screwed shut so not able to check rear seat mount areas

Vehicle structure is corroded but structural rigidity is not significantly reduced various locations (6.1.1 (c) (i))