2000 Mazda MX-5

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Registration plate inscription illegible (0.1 (b))

Nearside Front passenger door cannot be opened from outside the vehicle (6.2.3 (a))

Nearside Headlamp not working on main beam offside (4.1.1 (a) (ii))

Nearside Parking brake inoperative on one side and offside (1.4.1 (a))

Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Brake hose connection leaking on a hydraulic braking system at calliper (1.1.12 (c) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output offside (4.1.4 (b))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Headlamp lens slightly defective and offside front (4.1.1 (b) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Inner and offside rear inner sills corroding

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

All direction indicators flashing more than 120 times a minute (4.4.4 (a))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis leg and offside (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area damaged but not considered excessive sill (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Headlamp not working on main beam both (4.1.1 (a) (ii))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

All direction indicators flashing more than 120 times a minute (4.4.4 (a))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis leg and offside (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Outer sill corroded

Fluid leak harmful to the environment or a risk to other road users p/steering pipe? (8.4.1 (a) (i))

Nearside Front Brake linkage has restricted free movement (1.1.15 (e))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced corner sill floor (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced corner sill floor (6.1.1 (c) (i))

Offside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Brake lever has insufficient reserve travel (1.1.2 (a))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Shock absorber has a slightly worn bush (2.7.4)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Oil leak ()

Rear brake disc worn, pitted or scored, but not seriously weakened both (3.5.1i)

brake pedal anti slip rubber worn

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Mechanical brake component has restricted free movement (3.5.1k)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Shock absorber has a slightly worn bush (2.7.4)

Offside Front tyre perishing inner wall

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Oil leak ()

Rear brake disc worn, pitted or scored, but not seriously weakened both (3.5.1i)

brake pedal anti slip rubber worn

Central Front Oil leak ()

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

oil leak

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear coil spring broken (2.4.C.1a)

oil leak

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Drive shaft which forms part of the suspension coupling gaiter damaged, but preventing the ingress of dirt (2.4.G.4e)

Brake master cylinder leaking hydraulic fluid (3.6.G.1f)

hand brake travel on max limit