2000 Jeep Wrangler Sahara Auto

Front All direction indicators not working (4.4.1 (a) (ii))

Front Hazard warning switch inoperative (4.4.2 (a) (ii))

Nearside Rear Upper Anti-roll bar linkage corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Upper Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Service brake excessively binding both sides (1.2.1 (f))

Front Windscreen washer not working (3.5 (a))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Upper Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material Along Chassis (1.1.11 (c))

Nearside Rear Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar has excessive play in a ball joint (2.4.G.2)

FRONT TO REAR BRAKE PIPE CORRODED. BOTH REAR AXLE BRAKE PIPES CORRODED. FRONT BRAKE DISCS CORRODED/PITTED

all original brake pipes corroded

Brake pipes corroded at rear. Rear brake balance just achieved. Movement/play in steering wheel.

Front registration plate character(s) incorrectly spaced (6.3.4a)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside rear brake recording little or no effort (3.7.B.5a)

Rear registration plate character(s) incorrectly spaced (6.3.4a)

Service brake: efficiency below requirements (3.7.B.7)