2010 Mazda Bongo

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Direction indicator not working (4.4.1 (a) (ii))

Windscreen washer not working both (3.5 (a))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive Sill area (5.3.6 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive Sill area (5.3.6 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Central Rear Upper Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Central Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Rear Passenger seat(s) missing at time of test

Nearside Front Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Rear Position lamp showing white light to the rear (4.2.3 (a) (ii))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Central Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Rear Passenger seat(s) missing at time of test

Central Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Exhaust has a minor leak of exhaust gases flexi (6.1.2 (a))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Passenger seat(s) missing at time of test

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Central Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Exhaust has a minor leak of exhaust gases flexi (6.1.2 (a))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Passenger seat(s) missing at time of test

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Rear Exhaust system insecure (6.1.2 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Dipswitch does not operate immediately when selected on dipped beam (4.1.3 (b))

Exhaust system insecure (6.1.2 (a))

Headlamp aim not tested (4.1.2 (b))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Headlamp not working on dipped beam both (1.7.5a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Stop lamp not working (1.2.1b)

rear brake pads getting low

slight binding o/s/r brake

Nearside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Suspension joint nearside lower dust cover split/missing

Suspension joint offside lower dust cover split/missing