2000 Rover Mini

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Direction indicator incorrect colour (4.4.3 (a))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Side repeater not working (4.4.1 (a) (ii))

Clutch fluid low

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Front Steering rack gaiter damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

all 4 shock absorber lower bushes worn but not excessively

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust emissions - engine idle speed too high (8.2.1.2 (e))

Nearside Rear Shock absorbers insecurely attached Upper mounting (5.3.2 (a) (i))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt Insecure (6.1.7 (g) (ii))

Offside Rear Shock absorbers insecurely attached Upper mounting (5.3.2 (a) (i))

Rear fog lamp missing (4.5.1 (a) (ii))

Windscreen washer not working (3.5 (a))

Driver's seat insecure (6.2.5 (a) (ii)) DANGEROUS

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

all 4 shock absorber lower bushes worn but not excessively

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength Floorpan corroded, rear mounting point of front subframe (5.3.6 (a) (i))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner arch, front mounting point (5.3.6 (a) (i))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength rear mounting point (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced Outer sill b-post area (7.1.1 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced sill/doorshut corroded (7.1.1 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength rear mounting point (5.3.6 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Driver's seat insecure (6.2.5 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced outer sill (6.1.1 (c) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced floorpan corroded, seat mounting area (6.1.1 (c) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive Floorpan around rear mounting (5.3.6 (a) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt both sides (2.5.C.1a)

Front Lower Shock absorber has a slightly worn bush both sides (2.7.4)

Nearside Rear tyre worn on inner edge & perished

Offside Front Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Parts of floor pan corroded

Offside Headlamp aim too low (1.8)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt both sides (2.5.C.1a)

Front Lower Shock absorber has a slightly worn bush both sides (2.7.4)

Nearside Rear tyre worn on inner edge & perished

Offside Front Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Parts of floor pan corroded

Floor pan corroded in parts

NSR tyre perished and worn on edges

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Parking brake lever has little reserve travel (3.1.6b)

Bootlid cannot be secured in the closed position (6.4.1)

Emissions not tested (7.3.A.1)

Floor pan corroded in parts

NSR tyre perished and worn on edges

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Parking brake lever has little reserve travel (3.1.6b)

Battery insecure (1.9.1)

Electrical wiring insecure Alternator wire (1.9.2a)

Electrical wiring insecure Nearside front inner arch (1.9.2a)

Electrical wiring insecure Under dash (1.9.2a)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Inner Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Suspension arm ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Track rod end loose (2.2.B.1d)

Nearside rear brake binding (3.7.B.1)

Offside Front Suspension arm ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Headlamp aim too low and too far to the right. (1.8)

Offside Side repeater missing (1.4.A.2b)

Offside Track rod end loose (2.2.B.1d)

Offside rear brake binding (3.7.B.1)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Floor pan corroded in places

NSR tyre perished & worn on edges

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Parking brake lever has little reserve travel (3.1.6b)

Certain areas of chassis/body corroded

NSR tyre perished & worn on innner edge

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Certain areas of chassis/body corroded

NSR tyre perished & worn on innner edge

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

front subframe bushes soft

Nearside Front Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Nearside Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim too high (1.8)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front Sub-frame attachment rubber mounting bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim too low (1.8)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Rear fog lamp missing (1.3.2a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

front subfame buses soft,slight play in front suspension joints,exhaust to gearbox mount insecure

Nail in nearside rear tyre

BOTH FRONT TYRES WORN LOW ON INNER EDGES.

FRONT WIPER BLADES DON'T PARK CORRECTLY.

Nearside Front Direction indicators not working (1.4.A.2c)

Nearside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

BOTH FRONT TYRES WORN LOW ON INNER EDGES.

FRONT WIPER BLADES DON'T PARK CORRECTLY.

Nail in nearside rear tyre

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Front Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Steering rack gaiter split (2.2.D.2d)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

o/s rear brake binding slightly

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Rear fog lamp not working (1.3.2b)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)