2000 Honda XL125

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Wheel has a slightly distorted bead rim. (4.2.2)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Wheel has a slightly distorted bead rim. (4.2.2)

Front Wheel has a slightly distorted bead rim. (4.2.2)

Drive chain excessively loose (6.2.1d)

Front Wheel has a slightly distorted bead rim. (4.2.2)

Rear Exhaust slightly deteriorated (7.1.1a)

Rear Wheel damaged but not significantly reducing the original strength (4.2.1a)

Rear Wheel spoke slightly loose. (4.2.1b)

Front Drive chain sprocket worn to excess (6.2.1e)

Front Hydraulic brake control feels spongy (3.1.4a)

Front Steering movement excessively 'notchy' with the weight on the lower bearing (2.2.1a)

Front Throttle operating incorrectly (6.2.1f)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Drive chain worn to excess (6.2.1e)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Wheel has an excessively distorted bead rim. (4.2.2)

Rear Exhaust slightly deteriorated (7.1.1a)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Rear Locking device(s) not correctly fitted which may make the motor bicycle dangerous to ride (6.2.1h)

Rear Wheel has an excessively distorted bead rim. (4.2.2)

Rear Wheel spoke excessively loose (4.2.1b)

Rear Wheel spoke missing (4.2.1b)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Steering movement excessively 'notchy' with the weight on the lower bearing (2.2.1a)

Steering movement excessively 'notchy' with the wheel raised (2.2.1b)

Drive chain worn but not considered excessive (6.2.1e)

Front Wheel has a slightly distorted bead rim. (4.2.2)

near side side pannel insecure

rear sprocket/wheel worn