2000 Audi S3

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Coolant leak

Oil leak

exhaust rubber broken

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Brake pipe inadequately clipped (3.6.B.1)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Coolent Leek

Lamda Sensor Not Conected

N/S/F Tyre Has Outer Side Wall Damage

N/S/R Tyre Has Cut In Side Wall

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

O/S/F Outer Side Wall Damage

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Suspension Sensor Broken N/S/R

nearside rear tyre split om inside edge

Exhaust system not adequately supported (7.1.1)

Nearside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

nearside rear tyre split om inside edge

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

lamda wires cut

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too low (1.8)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Tyre worn close to the legal limit (4.1.E.1)

Centre Front Exhaust has a part missing (7.1.1a)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Front Exhaust has part of the system excessively deteriorated (7.1.1a)

Front registration plate character(s) incorrectly spaced (6.3.4a)

Offside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Rear registration plate character(s) incorrectly spaced (6.3.4a)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

a few bulbs in high level brake light not working