2008 Proton Persona

Brake pedal has insufficient reserve travel (1.1.2 (a))

Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced crossmember (6.1.1 (c) (i))

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt drop link (5.3.4 (b) (ii))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt drop link (5.3.4 (b) (ii))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Rear Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge close to limit (5.2.3 (e))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge close to limit (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge close to limit (5.2.3 (e))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Driver's door cannot be opened from inside the vehicle (6.2.3 (a))

Emissions not tested smokey (8.2.1.2 (d))

Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt both (5.3.4 (b) (ii))

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Front passenger door cannot be opened from outside the vehicle (6.2.3 (a))

Offside Front Headlamp aim not tested (4.1.2 (b))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Rear Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt both (5.3.4 (b) (ii))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Rear Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Engine management light on

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Chassis rail area near anti roll bar mounting bracket (2.4.A.3)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Engine management light on

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Chassis rail area near anti roll bar mounting bracket (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis rail area near to anti roll bar mounting bracket (2.4.A.3)

Horn not working (1.6.2a)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Front wheel bearing rough when rotated (2.5.A.2)

Registration plate lamp not working Both rear (1.1.C.1d)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis rail area near to anti roll bar mounting bracket (2.4.A.3)

Offside Obligatory mirror deteriorated, but not seriously affecting the rear view (8.1.2a)

engine oil leak from oil pressure warning light switch

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake lever has no reserve travel (3.1.6b)

Rear rear parking brake recording little or no effort (3.7.B.6a)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

rear brake discs