2009 Mercedes Ml 250

Brake disc worn, pitted or scored, but not seriously weakened front and rear discs worn pads low (1.1.14 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Rear Brake cable damaged but not to excess handbrake cable (1.1.15 (a))

Offside Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Inner Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Inner Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Nearside Rear exhaust shield getting insecure

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Headlamp aim unable to be tested (4.1.2 (b))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Lower Bumper damaged and likely to cause injury when grazed or contacted (6.1.4 (a) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Inner Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Nearside Rear exhaust shield getting insecure

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Front fog lamp not working (4.5.1 (a) (ii))

Nearside Front Tyre worn on edges.

Offside Front Tyre worn on edges.

Nearside Front Side repeater not working (1.4.A.2c)

Nearside Front Tyre worn on edges.

Offside Front Tyre worn on edges.

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Headlamp not working on dipped beam (1.7.5a)

n/s/f tyre getting low on edges and deep cut on outer side wall

n/s/f tyre getting low on edges and deep cut on outer side wall