2007 Mazda Bongo

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced Outer Sill (6.1.1 (c) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Central Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Central Front Windscreen washer not working (3.5 (a))

Nearside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner arch (6.2.2 (d) (i))

Nearside Rear Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner arch (6.2.2 (d) (i))

Offside Rear Inner Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting (6.2.2 (d) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner arch (6.2.2 (d) (i))

Central Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Rear fog lamp not working (4.5.1 (a) (ii))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Lower Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner jacking block (6.1.1 (c) (i))

Offside Front Lower Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner jacking block (6.1.1 (c) (i))

Offside Rear Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Steering locking device ineffective key cannot be removed (2.1.3 (d))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Inner Vehicle structure is corroded but structural rigidity is not significantly reduced middle sill (6.1.1 (c) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened nearside and offside (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin nearside and offside (1.1.13 (a) (ii))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside sills corroded and weld repair

Offside sills corroded and weld repair

Rear Brake disc worn, but not excessively corroded (1.1.14 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside sills corroded and weld repair

Offside sills corroded and weld repair

Rear Brake disc worn, but not excessively corroded (1.1.14 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Parking brake lever has no reserve travel (3.1.6b)

Nearside Front Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Rear tyre perrished

Offside Front Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)