2006 Nissan Cube

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor section (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage insecurely attached (5.3.3 (a) (i))

Offside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor section (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear fog lamp does not emit a steady red light (4.5.4 (a))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor area (5.3.6 (a) (i))

Front Radiator support excessively corroded

Offside Front outer sill excessively corroded but not within prescribed area

Offside Rear chassis excessively corroded but not within prescribed area

Rear Exhaust mounting defective (6.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Lower Radiator mounting panel corroded

Sills have corrosion

Brake performance not tested (1.2.1 (g))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength 3 holes (5.3.6 (a) (i))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength 3 large holes (5.3.6 (a) (i))

Offside Rear fog lamp lens defective such that emitted light is adversely affected (4.5.1 (b) (ii))

Central Front Body not fully secure cross member (6.2.2 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Lower Radiator support cross member corroded but outside prescribed area and still secure

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Floor corroded but outside prescribed area

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Chassis corroded but outside prescribed area

Offside Rear Floor corroded but outside prescribed area

Rear Registration plate lamp insecure (4.7.1 (c) (i))

Offside Front Inner Tyre worn close to the legal limit edge (4.1.E.1)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Inner Tyre worn close to the legal limit edge (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Registration plate lamp insecure (1.1.C.1c)

Front Brake binding slightly

Nearside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Brake binding slightly

Offside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Slight movement in N/S/F wheel/steering

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Slight movement in N/S/F wheel/steering