2002 Mazda Bongo

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Central Exhaust emissions likely to be affected by an exhaust leak exhaust flexi (8.2.1.1 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced panel (6.1.1 (c) (i))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Body panel insecure bumper (6.2.1 (a) (i))

Nearside Rear Inner Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced panel above exhaust (6.1.1 (c) (i))

Offside Front Headlamp aim too far to the right (4.1.2 (a))

Offside Rear Inner Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Inner Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))

Central Exhaust has a minor leak of exhaust gases flexi (6.1.2 (a))

Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

n/s/f brake slightly binding

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Headlamp aim too high (4.1.2 (a))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Central Exhaust has a minor leak of exhaust gases flexi (6.1.2 (a))

Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

n/s/f brake slightly binding

Front Integral body structure is corroded but structural rigidity is not significantly reduced Crossmember (6.1.1 (c) (i))

Front Integral body structure is corroded but structural rigidity is not significantly reduced Out rigger (6.1.1 (c) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced Inner sill (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced Inner sill (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Oil leak

osf and nsf tyre cracking ok at time of test.

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

osf and nsf tyre cracking ok at time of test.