2005 Honda XR250

Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Motorcycle structure is deformed but structural rigidity is not significantly reduced Offside riders footrest mounts (6.1.1 (a) (i))

Rear Brake binding but not excessively (1.2.1 (f))

Rear tyre perishing

Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Drive chain so loose it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Drive chain so worn it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Rear Drive chain sprocket so worn it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Stop lamp does not illuminate by the operation of both brake controls Front brake does not illuminate the stop lamp (4.3.2 (a) (iii)) DANGEROUS

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Chain and sprockets slightly worn and very dry

Rear Brake binding but not excessively (1.2.1 (f))

Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Offside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Front Tyre has a tear caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Chain and sprockets slightly worn and very dry

Rear Brake binding but not excessively (1.2.1 (f))

Offside Front shock absorber has light misting of stanchion (2.3.3)

front tyre slightly perished

Front suspension assembly slightly corroded. (2.3.1)

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear shock absorber has inadequate damping effect. (2.4.A.3b)

Rear shock absorber has inadequate damping effect. (2.4.A.3b)

Throttle operating incorrectly (6.2.1f)

Front shock absorber has light misting of stanchion (2.3.3)

Brake lever is bent but brake can still be readily applied (3.1.3c)

Rear Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Front Brake pad(s) close to minimum limit (3.2A1f(ii))

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)