2008 Piaggio Fly

Front Shock absorber has a light misting of oil (5.3.2 (b))

Rear Brake performance not tested could not perform rear brake test due to completely flat rear tyre (1.2.1 (g))

Registration plate lamp does not illuminate simultaneously with the position lamp(s) (4.7.2 (a))

Front Stop lamp remains on when the brakes are released (4.3.2 (a) (iii)) DANGEROUS

Rear Tyre has a tear caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Shock absorber has a light misting of oil (5.3.2 (b))

Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Front slightly reduced front damping.

Front Brake lever has insufficient reserve travel (1.1.2 (a))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Front Brake fluid reservoir fluid not visible (1.1.10 (d) (iii)) DANGEROUS

Front Tyre tread not clearly visible (5.2.3 (e)) DANGEROUS

Front Roller brake test indicates a sticking brake (3.3.A1a) DANGEROUS

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a) DANGEROUS

Indicator switch defective (1.5.4) DANGEROUS

Rear Tyre worn close to the legal limit (4.1.3(ii))

rear tyre has a punture

Rear no plate light not working

Front Roller brake test indicates a sticking brake (3.3.A1a) DANGEROUS

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front Roller brake test indicates a binding brake (3.3.A1a) DANGEROUS

Front Tyre worn close to the legal limit (4.1.3(ii))