2000 Honda Integra

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Coil spring corroded both (5.3.1 (b) (i))

Windscreen washer not working (3.5 (a))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Registration plate lamp missing in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Coil spring corroded both (5.3.1 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Registration plate lamp insecure (4.7.1 (c) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced wheel arch (6.1.1 (c) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated clip (6.1.7 (g) (i))

Offside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced wheel arch (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Windscreen seriously discoloured but not adversely affecting driver's view stone chip (3.2 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too low (1.8)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Bonnet stay missing

Centre Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside beam pattern weak

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Sill covers fitted to offside and nearside

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nail in offside rear tyre

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Windscreen wiper blade deteriorated (8.2.2)