2000 Mitsubishi Challenger

Central Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

the whole underside is covered in underseal

Central Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Body panel damaged and likely to cause injury (6.2.1 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

the whole underside is covered in underseal

Brake pipe corroded, covered in grease or other material NSF and OSF (1.1.11 (c))

Coil spring corroded Both rear (5.3.1 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Suspension spring mounting prescribed area is corroded but not considered excessive NSR and OSR (5.3.6 (a) (i))

Offside Windscreen washer provides insufficient washer liquid (3.5 (a))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer face of NSR chassis near trailing arm mounting (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material NSF and OSF (1.1.11 (c))

Coil spring corroded Both rear (5.3.1 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Suspension spring mounting prescribed area is corroded but not considered excessive NSR and OSR (5.3.6 (a) (i))

Front Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material after hose (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material before valve (1.1.11 (c))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Suspension spring mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Rear body both sides corroded

Front Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Headlamp aim too high both sides (4.1.2 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material after hose (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material before valve (1.1.11 (c))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Suspension spring mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Rear body both sides corroded

Front suspension has slight play in a lower suspension ball joint both sides (2.5.B.1a)

Rear Anti-roll bar has slight play in a pin/bush both sides (2.4.G.2)

Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement both sides (2.4.G.2)

Rear Brake pipe slightly corroded after hose (3.6.B.2c)

Rear Brake pipe slightly corroded before valve (3.6.B.2c)

Central Exhaust has a minor leak of exhaust gases middle (7.1.2)

Anti-roll bar has slight play in a pin/bush Both front outer bushes (2.4.G.2)

Brake pipe excessively corroded Above NSR spring (3.6.B.2c)

Brake pipe excessively corroded On NSR chassis next to fuel tank (3.6.B.2c)

Anti-roll bar has slight play in a pin/bush Both front outer bushes (2.4.G.2)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Vehicle structure slightly corroded within 30cm of towbar mounting (6.6.6)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Emissions not tested (7.3.A.1)

Inner Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Vehicle structure slightly corroded within 30cm of towbar mounting (6.6.6)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Nearside Front Upper Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Steering pivot point has slight play (2.2.B.1g)

Offside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Upper Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

n/s front tyre worn on outer edge.

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Rear Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Rear Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front brake disc slightly pitted (3.5.1h)

Nearside Rear brake disc slightly pitted (3.5.1h)

Offside Front brake disc slightly pitted (3.5.1h)

Offside Rear brake disc slightly pitted (3.5.1h)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Brake pipe excessively corroded (3.6.B.2c)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front brake disc slightly pitted (3.5.1h)

Nearside Rear brake disc slightly pitted (3.5.1h)

Offside Front brake disc slightly pitted (3.5.1h)

Offside Rear brake disc slightly pitted (3.5.1h)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Brake load sensing valve linkage seized (3.6.E.3)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear brake disc slightly pitted (3.5.1h)

Brake pad(s) wearing thin (3.5.1g)