2010 Mazda Bongo

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Emissions unable to be completed Exhaust blow (8.2.1.2 (d))

Nearside Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement d-bush (5.3.4 (a) (i))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement d-bush (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement d-bush (5.3.4 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement d-bush (5.3.4 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Oil leaking excessively from engine (8.4.1 (a) (i))

Brake pipe corroded, covered in grease or other material front to back (1.1.11 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Tyre tread depth below requirements of 1.6mm inner edge (5.2.3 (e)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced under body (6.1.1 (c) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output needs cleaning just ok at time (4.1.4 (b))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output needs cleaning just ok at time of test (4.1.4 (b))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Upper Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

exhaust deteriorated slightly but not leaking

Body has slight corrosion under body (6.1.B.2)

Nearside Front Lower Suspension arm corroded but not seriously weakened (2.4.G.1)

Offside Front Lower Suspension arm corroded but not seriously weakened (2.4.G.1)

front and rear brake pads obscured unable to fully check

Body has slight corrosion under body (6.1.B.2)

front and rear suspension corroded

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Rear fog lamp not working (1.3.2b)

Centre Stop lamp has light sources not illuminating, but not more than 50% (1.2.1b)

Exhaust has a minor leak of exhaust gases (7.1.2)

slight corrosion of sills and n/s/r wheel arch

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

headlamp paterns slightly deteriorated

Anti-lock braking system warning lamp does not illuminate (3.4.1b)

Rear fog lamp not working (1.3.2b)

Offside Rear Rear fog lamp has light sources not illuminating, but not more than 50% (1.3.2b)

headlamp paterns slightly poor

n/s wiper blade slightly poor

Anti-lock braking system warning lamp does not illuminate (3.4.1b)

o/s/r tail lamp [1of2] not working