2003 Toyota Harrier

Brake pad(s) wearing thin REAR (1.1.13 (a) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Fuel Pipe/s corroded ()

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Upper Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Stop lamp not working (1.2.1b)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Rear Shock absorber has negligible damping effect (2.7.5)

Offside Rear Shock absorber has negligible damping effect (2.7.5)

Offside Inner Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Front brake disc excessively pitted (3.5.1h)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Registration plate lamp flickers when tapped lightly by hand (1.1.5e)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear brake disc excessively pitted (3.5.1h)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc excessively pitted (3.5.1h)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Outer Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Rear Registration plate lamp not working (1.1.5c)

Rear brake disc excessively pitted (3.5.1h)

Rear Brake pad(s) wearing thin (3.5.1g)