2000 Fiat Hymer

Brake pipe corroded, covered in grease or other material All pipes covered with underseal. (1.1.11 (c))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength WITHIN 30CM ONLOWER SUSPENSION BOLTS (MARKED (5.3.6 (a) (i))

Nearside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting SILL (MARKED) (6.2.2 (d) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength WITHIN 30CM ONLOWER SUSPENSION BOLTS (MARKED (5.3.6 (a) (i))

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting SILL (MARKED) (6.2.2 (d) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Brake pipe corroded, covered in grease or other material all brake pipes covered in grease (1.1.11 (c))

Exhaust mounting defective exhaust front mounting missing but still secure rubber mountings perished (6.1.2 (a))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Brake pipe corroded, covered in grease or other material all brake pipes covered in grease (1.1.11 (c))

Exhaust mounting defective (6.1.2 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement lower bushes splitting (5.3.4 (a) (i))

Headlamp levelling device inoperative (4.1.5 (a))

Offside Headlamp aim too low (4.1.2 (a))

Brake pipe corroded, covered in grease or other material all brake pipes covered in grease (1.1.11 (c))

Exhaust mounting defective (6.1.2 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement lower bushes splitting (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement lower bushes splitting (5.3.4 (a) (i))

Exhaust mounting defective mounting rubbers perished (6.1.2 (a))

Front Exhaust mounting defective mounting rubbers missing (6.1.2 (a))

Exhaust mounting defective rubber mountings rings perished (6.1.2 (a))

slight cracking on all 4 tyre side walls

Nearside Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)