2000 Audi S3

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Electronic stability system warning lamp indicates a fault (3.4.1c)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front Headlamp cleaning device inoperative (1.7.2)

Nearside Front Tyre(s) incorrect because a lightweight or space saving wheel is fitted (4.1.A.1b)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Headlamp not working on dipped beam (1.7.5a)

Rear Headlamp levelling device inoperative (1.7.2)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

4wd system noise

Offside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Inner Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

fuel filter corroaded

gear linkage stiff

Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2) DANGEROUS

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2) DANGEROUS

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Inner Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Inner Front brake disc excessively pitted (3.5.1h)

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Nearside Registration plate lamp not working (1.1.5c)

Nearside Stop lamp not working (1.2.1b)

Offside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Offside Inner Front brake disc excessively pitted (3.5.1h)

Offside Front coil spring fractured (2.4.C.1a) DANGEROUS

Front Brake pad(s) wearing thin (3.5.1g)

Rear brake disc slightly pitted (3.5.1h)

n/s/f tyre has damage to sidewall but cords not exposed

rear suspension level sensor cabletied to link rod

all 4 tyres low

Offside Rear Registration plate lamp not working (1.1.5c)

all 4 tyres low