2000 Yamaha DT125

Drive chain slightly tight (6.1.7 (k) (i))

Drive chain sprocket worn, but not excessively Front sprocket slightly worn (6.1.7 (c) (i))

O/S mirror loose

Rear brake line rubbing slightly, on rear shock coil

Steering headbearing has slight free play (2.2.2 (f) (i))

Suspension arm pin, bush or joint worn but not resulting in excessive movement Rear shock to swing arm linkage has play (5.3.4 (a) (i))

Rear brake disc missing a mounting bolt but secure

All position lamps not working Front and rear position lamps not working (4.2.1 (a))

Registration plate lamp does not illuminate simultaneously with the position lamp(s) (4.7.2 (a))

Drive chain slightly tight (6.1.7 (k) (i))

Drive chain sprocket worn, but not excessively Front sprocket slightly worn (6.1.7 (c) (i))

O/S mirror loose

Rear brake line rubbing slightly, on rear shock coil

Steering headbearing has slight free play (2.2.2 (f) (i))

Suspension arm pin, bush or joint worn but not resulting in excessive movement Rear shock to swing arm linkage has play (5.3.4 (a) (i))

Rear brake disc missing a mounting bolt but secure

Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Position lamp not working New bulb fitted (4.2.1 (a))

Registration plate deteriorated but not likely to be misread (0.1 (b))

All direction indicators not working (4.4.1 (a) (ii))

All position lamps not working (4.2.1 (a))

Drive chain excessively loose (6.1.7 (c) (i))

Headlamp aim too high (4.1.2 (a))

Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii)) DANGEROUS

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Horn not working (1.7.3a)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Drive chain worn but not considered excessive (6.2.1e)

Front wheel bearings are slightly rough (2.3.5b)

Headlamp aim beam image kick up to the offside (1.6)

Headlamp aim too high (1.6)

Lower Rear mono-shock pivot worn but not excessive (2.4.B.4)

Drive chain worn but not considered excessive (6.2.1e)

Front wheel bearings are slightly rough (2.3.5b)

Lower Rear mono-shock pivot worn but not excessive (2.4.B.4)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))