2000 Yamaha YZF600

Drive chain excessively loose (6.1.7 (c) (i))

Front Shock absorber has a serious fluid leak (5.3.2 (b))

Rear Suspension rod modified so the suspension is inoperative (5.3.3 (c) (ii)) DANGEROUS

ignition switch worn allowing engine and lights to go off

Front Brake pad(s) contaminated (1.1.13 (b))

Headlamp aim too low (4.1.2 (a))

Offside Front Shock absorber has a serious fluid leak fork seal (5.3.2 (b))

Stop lamp not working when operating front or rear brakes (4.3.1 (a) (ii))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Rear Stop lamp not working (4.3.1 (a) (ii))

Bolt missing from o/s engine mounting.

Rear reflector on motorcycle missing (1.4.1)

Bolt missing from o/s engine mounting.

Drive chain slightly loose (6.2.1d)

Rear Brake disc(s) slightly worn (3.2.A1l)

Front wheel bearings have excessive free play (2.3.5b)

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Drive chain slightly loose (6.2.1d)

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Brake disc(s) slightly worn (3.2.A1l)

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front Tyre worn close to the legal limit (4.1.3(ii))

Drive chain excessively loose (6.2.1d)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear suspension bearing has excessive free play (2.4.A2a(i))

Rear Lower Rear suspension bush has slight free play (2.4.A2a(i))

Rear Tyre valve stem slightly damaged (4.1.2c)

Rear Brake disc(s) cracked (3.2.A1g)

Rear Rear reflector on motorcycle missing (1.4.1)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

speedo drive gear not fitted correctly on front wheel.

Front Tyre worn close to the legal limit (4.1.3(ii))

advise front pads getting low near wear limit,