2000 Aprilia RS 50

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Brake pedal has slight side movement indicating a worn pedal bearing or pivot (1.1.1 (b))

Chain guard missing ()

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Front Mudguard insecure ()

Front Tyre worn close to the legal limit And perished (5.2.3 (e))

Rear Lower Shock absorber slightly loose Rubber worn (5.3.2 (a) (i))

Brake pedal has slight side movement indicating a worn pedal bearing or pivot (1.1.1 (b))

Chain guard missing ()

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Front Mudguard insecure ()

Front Tyre worn close to the legal limit And perished (5.2.3 (e))

Headlamp aim too low (4.1.2 (a))

Rear Lower Shock absorber slightly loose Rubber worn (5.3.2 (a) (i))

Offside Rear Lower Brake pad(s) close to minimum limit (3.2.A1f(i))

Centre Rear Lower Rear suspension bush has excessive free play (2.4.A2a(i))

Offside Rear Lower Brake pad(s) close to minimum limit (3.2.A1f(i))

Clutch lever shortened. (6.2.1g)

Front Tyre worn close to the legal limit (4.1.3(i))

Front Wheel corroded but not significantly reducing the original strength (4.2.1a)

Rear mono-shock pivot worn but not excessive (2.4.B.4)

Rear suspension bush has slight free play (2.4.A2a(i))

Rear Rear suspension bush has slight free play (2.4.A2a(i))

Front position lamp incorrect colour (1.1.2a)

Rear Rear suspension bush has slight free play (2.4.A2a(i))

Rear Rear wheel bearings are excessively rough (2.4.A.2c)

Rear Rear shock absorber has inadequate damping effect. (2.4.A.3b) DANGEROUS

Rear Rear suspension bearing has slight free play (2.4.A2a(i))

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Offside Front Front shock absorber seal failed and leaking oil (2.3.3)

Rear Brake pedal has inadequate reserve travel (3.1.3b)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

rear brake pad in wrong way round