2005 Hyosung GT 125 Comet

Front Tyre worn close to the legal limit (5.2.3 (e))

Nearside Front Shock absorber has negligible damping effect (5.3.2 (b))

Offside Front Shock absorber has negligible damping effect (5.3.2 (b))

Front Tyre worn close to the legal limit (5.2.3 (e))

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Offside Front Shock absorber has a light misting of oil (5.3.2 (b))

Chain guard missing

Steering headbearing has slight free play (2.2.2)

Drive chain worn but not considered excessive (6.2.1e)

Front Brake lever is short but brake can still be readily applied (3.1.3c)

Headlamp masks/converters fitted

Rear Drive chain sprocket slightly worn (6.2.1e)

Steering headbearing has slight free play (2.2.2)

Wheel alignment slightly misaligned. (2.5.1)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Footrest missing (6.2.1a)

Rear Tyre has a lump caused by separation or partial failure of its structure (4.1.2a(ii))

Rear wheel bearings have excessive free play (2.4.A.2c)

Drive chain slightly tight (6.2.1d)

Drive chain worn but not considered excessive (6.2.1e)

Front Brake lever is short but brake can still be readily applied (3.1.3c)

Headlamp aim beam image kick up to the offside (1.6)

Headlamp masks/converters fitted

Rear Drive chain sprocket slightly worn (6.2.1e)

Steering headbearing has slight free play (2.2.2)

Wheel alignment slightly misaligned. (2.5.1)

Drive chain excessively loose (6.2.1d)

Drive chain worn to excess (6.2.1e)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear reflector on motorcycle missing (1.4.1)

Rear wheel bearings have excessive free play (2.4.A.2c)

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

front brake laver damaged

rear tyre cracking advise replace

Rear Brake disc(s) is excessively distorted (3.2.A1m)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Drive chain slightly loose (6.2.1d)

Front Brake disc(s) slightly worn (3.2.A1l)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

slight binding on front brake