2012 Mazda 3

Offside Front Headlamp lens slightly defective lens discoloured pattern just visible (4.1.1 (b) (i))

Oil leak, but not excessive engine area (8.4.1 (a) (i))

Oil leak, but not excessive gearbox area (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin inner pads seem low (1.1.13 (a) (ii))

Rear Exhaust mounting defective hanger corroded off but supported (6.1.2 (a))

both front fog lights not working

oil below limit only just on dipstick

Offside Headlamp lens slightly defective lens poor but just has enough image (4.1.1 (b) (i))

both sides front fog lights not working

Front Position lamp not working both sides front (4.2.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

Offside Headlamp lens slightly defective lens poor but just has enough image (4.1.1 (b) (i))

both sides front fog lights not working

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Rear Inner Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Rear Inner Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Front Inner Brake pad(s) wearing thin (3.5.1g)