2008 Suzuki Marauder

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust system insecure (6.1.2 (a))

Front Brake excessively binding (1.2.1 (f))

Rear Brake pedal has insufficient reserve travel (1.1.2 (a))

Rear Stop lamp not working (4.3.1 (a) (ii))

Front Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Front Brake binding but not excessively (1.2.1 (f))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Offside Rear Exhaust slightly loose (6.1.2 (a))

Rear damage to tyre sidewall

Front Brake disc(s) slightly worn (3.2.A1l)

Front Roller brake test indicates a slightly grabbing brake (3.3.A1b)

Headlamp aim too high and too far to the left. (1.6)

Stop lamp does not illuminate immediately a brake applies Rear brake control 2 (1.3.1a)

Brake performance not tested Front brake holding on in my opinion it is unsafe for me to put this in the brake rollers (3.3) DANGEROUS

Nearside Engine has a oil leak

Offside Front Brake lever is short but brake can still be readily applied (3.1.3c)

Offside wing mirror insecure

Rear wheel squeeking when rotated

Front Tyre worn close to the legal limit (4.1.3(ii))

Front Brake pad(s) (sintered type) less than 1.0mm thick (3.2A1f(ii))

Centre Front Horn not working (1.7.3a)

Front Tyre worn close to the legal limit (4.1.3(ii))

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Drive chain excessively tight (6.2.1d)

Drive chain sprocket carrier worn to excess (6.2.1e)

Drive chain worn to excess (6.2.1e)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Drive chain sprocket worn to excess (6.2.1e)

Rear Drive chain sprocket worn to excess (6.2.1e)

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Rear Brake lining(s) close to minimum limit (3.2.A1f(i))

Front wheel bearings are excessively rough (2.3.5b) DANGEROUS

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)