2010 Mazda Bongo

Nearside Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Oil leaking excessively from transmission pipe (8.4.1 (a) (i))

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Front Lower Vehicle structure is corroded but structural rigidity is not significantly reduced Cross member (6.1.1 (c) (i))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security wheel arch (6.2.2 (d) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill by lower wheel arch (5.3.6 (a) (i))

Nearside Front Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Front Lower Vehicle structure is corroded but structural rigidity is not significantly reduced Cross member (6.1.1 (c) (i))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened very rusty will need replacing soon (5.3.3 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Front Suspension arm corroded but not seriously weakened very rusty will need replacing soon (5.3.3 (b) (i))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security wheel arch (6.2.2 (d) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill by lower wheel arch (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively damaged significantly reducing structural strength chassis (5.3.6 (a) (i))

Nearside Rear Position lamp with a multiple light source more than 1/2 not functioning (4.2.1 (a) (ii))

Nearside Rear Shock absorbers has negligible damping effect (5.3.2 (d))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Shock absorbers has negligible damping effect (5.3.2 (d))

Offside Rear Shock absorbers has negligible damping effect (5.3.2 (d))

Offside Rear Suspension component mounting prescribed area excessively damaged significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Undertray likely to become detached (6.2.1 (a) (ii)) DANGEROUS

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner seal (5.3.6 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Rear Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Nearside Front Subframe mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Nearside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Nearside Rear position lamp(s) has less than 50% of the light sources illuminating (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Headlamp damaged but light output not reduced (1.7.5a)

Nearside Rear Tyre worn close to the legal limit on limit (4.1.E.1)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Rear Tyre worn close to the legal limit on limit (4.1.E.1)

Nearside Headlamp damaged but light output not reduced (1.7.5a)

Nearside Rear Tyre worn close to the legal limit on limit (4.1.E.1)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Rear Tyre worn close to the legal limit on limit (4.1.E.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Oil leak

nearside rear tyre worn on outer edge

windscreen slightly tinted

Nearside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Valve stem seriously damaged (4.1.D.1e)

Nearside Rear Valve stem seriously damaged (4.1.D.1e)

Offside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Valve stem seriously damaged (4.1.D.1e)

Offside Rear Valve stem seriously damaged (4.1.D.1e)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Oil leak

nearside rear tyre worn on outer edge

windscreen slightly tinted

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake pad(s) wearing thin (3.5.1g)