1999 Aprilia RS

h/lamp light output weak recommend further investigation.

Front Tyre valve stem damaged which could cause sudden tyre deflation (4.1.2c)

Front wheel bearings are excessively rough (2.3.5b)

Nearside Handlebar mounting clamp loose (2.1.1a)

h/lamp light output weak recommend further investigation.

Front Brake disc(s) slightly worn (3.2.A1l)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front wheel bearings are excessively rough (2.3.5b)

Offside Handlebar mounting clamp bolt loose (2.1.1a)

Rear Brake disc(s) excessively worn (3.2.A1l)

Rear Brake disc(s) friction surface contaminated by oil or grease (3.2.A1k)

Rear Floor brake test indicates a binding brake (3.3.C2c)

Rear Front wheel bearings are excessively rough (2.3.5b)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Rear reflector on motorcycle missing (1.4.1)

Riders seat insecure (6.2.1a)

Steering movement excessively 'notchy' with the wheel raised (2.2.1b)

Front Brake disc(s) slightly worn (3.2.A1l)

rear body work loose

Drive chain slightly loose (6.2.1d)

Rear Drive chain sprocket slightly worn (6.2.1e)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Registration plate with character(s) which are not the correct height (6.3.4a)

Drive chain slightly loose (6.2.1d)

Rear Drive chain sprocket slightly worn (6.2.1e)

Exhaust noisy (7.1.2)

Exhaust noisy (7.1.2)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear shock absorber has inadequate damping effect. (2.4.A.3b)

Drive chain slightly loose (6.2.1d)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear shock absorber has inadequate damping effect. (2.4.A.3b)

Rear shock absorber seal failed and leaking oil (2.4.A.1c)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.2)