2000 Iveco Daily

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced body mount (6.1.1 (c) (i))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced front of inner wheel arch (6.1.1 (c) (i))

Nearside Front Suspension component corroded and seriously weakened brake disk backing shield insecure (5.3.3 (b) (i))

Offside Front Body mounting fixings insecure rotten and loose (6.2.2 (c) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Rear Inner Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material all brake pipes (1.1.11 (c))

Coolant leak radiator ()

Integral body structure is corroded but structural rigidity is not significantly reduced both rear wheel arches inner arch to floor (6.1.1 (c) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced front bumper supports heavily corroded (6.1.1 (c) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced whole vehicle underside (6.1.1 (c) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive rear diff (8.4.1 (a) (i))

Brake load sensing valve stiff (1.1.17 (c) (i))

Brake pipe corroded, covered in grease or other material All (1.1.11 (c))

Front Inner flitches corroded, but welded from inside.

Integral body structure is corroded but structural rigidity is not significantly reduced Corrosion front to rear (6.1.1 (c) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Body mount repaired, Customer advised no more welded repairs to be carried out on this mount.

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting As marked (6.2.2 (d) (i))

Offside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Body out rigger( By seatbelt mount) rotten (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Body out rigger( By seatbelt mount) rotten (6.1.1 (c) (i))

Brake load sensing valve stiff (1.1.17 (c) (i))

Brake pipe corroded, covered in grease or other material All (1.1.11 (c))

Front Inner flitches corroded, but welded from inside.

Integral body structure is corroded but structural rigidity is not significantly reduced Corrosion front to rear (6.1.1 (c) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake pipe corroded, covered in grease or other material All (1.1.11 (c))

Front Integral body structure is corroded but structural rigidity is not significantly reduced Both front inner flitches have been welded from inside, Inner arches corroded But structurally strong (6.1.1 (c) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced Rear valance corroded (6.1.1 (c) (i))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Tyre slightly damaged/cracking or perishing Tyres perished (5.2.3 (d) (ii))

Welded repairs covered in underseal

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Out riggers front to rear corroded (6.1.1 (c) (i))

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Front to rear inner sill (6.1.1 (c) (i))

Offside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Inner and outer sill corroded front to rear. (Including where he arch meets the sill on the front) (6.1.1 (c) (i))

Offside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Out riggers corroded front to rear (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Brake disc worn, pitted or scored, but not seriously weakened Brake discs front and rear worn and pitted (1.1.14 (a) (ii))

Brake pipe corroded, covered in grease or other material Pipes covered in grease (1.1.11 (c))

Front Tyre slightly damaged/cracking or perishing Both front (5.2.3 (d) (ii))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge Worn on edge (5.2.3 (e))

Vehicle structure is corroded but structural rigidity is not significantly reduced Both front inner flitches welded from under bonnet (Inner wheel arches rotten from outside) structurally strong from top weld (6.1.1 (c) (i))

Offside Rear Stop lamp(s) all not working (4.3.1 (a) (iii))

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Cab mounting fixings insecure such that stability is seriously impaired (6.2.2 (c) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Rear Brake load sensing valve seized and ABS not fitted or inoperative (1.1.17 (c) (ii))

diff slight oil leak

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

diff slight oil leak

Service brake: efficiency below requirements (3.7.B.7)

Nearside Rear Rear reflector slightly damaged but function not impaired (1.5.1c)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Rear Registration plate lamp not working (1.1.C.1d)

Bonnet retaining device excessively deteriorated secondary catch (8.4.2)

Brake fluid warning lamp illuminated (3.6.G.2)

Offside Rear fog lamp not working (1.3.2b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Rear position lamp(s) adversely affected by the operation of another lamp both (1.1.A.3f)

Service brake: efficiency below requirements (3.7.B.7)

Steering system excessively tight (2.2.D.1)

vehicle has been converted into a motor home

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (3.6.C.3)

Emissions not tested (7.0)

Exhaust system not adequately supported (7.1.1)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7) DANGEROUS

Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (3.6.C.3)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Brake pipe excessively corroded (3.6.B.2c) DANGEROUS

Offside Front Brake pipe leaking (3.6.A.1) DANGEROUS

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Service brake: efficiency below requirements (3.7.B.7) DANGEROUS

N/S rear outrigger corroded but not within 30cm of body mount

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Offside rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

N/S front inner and outer sill to step excessively corroded but not within 30cm of any mounts

N/S front inner sill to step

O/S rear inner step to floor excessively corroded but not within 30cm of any mount

offside rear light lens has temp repair

rear brake discs coroded

offside rear light lens tempary repair

o/s rear lense repaired

Nearside Front Brake pipe inadequately clipped (3.6.B.1)

Nearside Headlamp aim too high (1.8)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Headlamp aim too high (1.8)

Offside Rear fog lamp not working (1.3.2b)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.5c)

o/s rear lense repaired

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Mechanical brake component has restricted free movement (3.5.1k)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Brake back plate(s) securing device excessively deteriorated (3.5.1j)

Offside Rear Mechanical brake component has restricted free movement (3.5.1k)

Offside Rear Rear fog lamp not working (1.3.2b)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Brakes imbalanced across an axle (3.7.B.5b)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Centre Exhaust has part of the system excessively deteriorated (7.1.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Rear Upper Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Upper Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)