1977 Triumph Spitfire

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Exhaust emissions likely to be affected by an exhaust leak from every joint (8.2.1.1 (b))

Offside Front Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting (6.2.2 (d) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Driver's seat backrest cannot be secured in the upright position. (6.2.5 (b) (ii)) DANGEROUS

Nearside Front Anti-roll bar linkage insecure and impairing directional stability (5.3.3 (a) (ii)) DANGEROUS

Nearside Front Anti-roll bar linkage likely to become detached (5.3.3 (a) (ii)) DANGEROUS

Nearside Front Lower Anti-roll bar linkage attachment bracket/mounting fractured suspension arm (5.3.3 (b) (ii)) DANGEROUS

Offside Front Anti-roll bar linkage insecure and impairing directional stability (5.3.3 (a) (ii)) DANGEROUS

Offside Front Anti-roll bar linkage likely to become detached (5.3.3 (a) (ii)) DANGEROUS

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Driver's door pillar deteriorated but the door can still be readily opened and closed (6.2.3 (c) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Oil leak, but not excessive gear box and rear differential casing (8.4.1 (a) (i))

Slight play offside front bottom wishbone mounting bushes.

Vehicle underbody heavily corroded but not holed.

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Lower Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

underside is heavily covered in underseal

Brake pedal spongy (3.3.B.1b)

Brakes imbalanced across an axle (3.7.B.5b)

Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Subframe mounting prescribed area is excessively corroded (2.4.A.3)

the whole vehicle has heavy corrosion unable to inspect correctly due to thick underseal