1983 Audi Coupe

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive wheel arch has corrosion (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area damaged but not considered excessive wheel arch has corrosion (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area damaged but not considered excessive wheel arch has corrosion (5.3.6 (a) (i))

Offside Rear bumper end cap is taped on

Nearside Front Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Front Windscreen washer provides insufficient washer liquid offside and nearside (3.5 (a))

Fuel system component leaking Fuel Filter is leaking (6.1.3 (b) (i))

Nearside Front Direction indicator missing lens missing/sharp edges (4.4.1 (a) (ii))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively wiper is insecure (3.4 (b) (ii))

Offside Front Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive Inner wing (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive Inner wing (5.3.6 (a) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced Floor pan (6.1.1 (c) (i))

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)

Brake pedal creeps down when held under pressure (3.3.B.1a)

Horn not working (1.6.2a)

Nearside Front Brake hose ferrule excessively corroded (3.6.B.4e)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Direction indicator adversely affected by the operation of another lamp (1.4.A.2h)

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Front Brake hose leaking (3.6.A.1)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Direction indicator adversely affected by the operation of another lamp (1.4.A.2h)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)