1999 Kymco Zing

Brake pedal not releasing correctly and functionality of brakes affected (1.1.2 (b) (ii))

Headlamp aim too low (4.1.2 (a))

Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Rear Footrest missing (6.2.12 (a))

Offside Rear Footrest missing (6.2.12 (a))

Rear Brake excessively binding (1.2.1 (f))

Rear reflector missing (4.8.2 (a) (ii))

Rear Brake pedal is bent and the brake cannot be readily applied (3.1.3c)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Headlamp aim too high (1.6)

Drive chain slightly loose (6.2.1d)

Drive chain slightly loose (6.2.1d)

Offside Direction indicator not working (1.5.1c)

horn operation, borderline pass

Front Tyre worn close to the legal limit (4.1.3(i))

Offside Outer Front Front shock absorber has light misting of stanchion (2.3.3)

of side front fork leg slight oil weeping

slight runout front wheel

Exhaust mounting does not fully support the exhaust system (7.1.1.c)

Rear Drive chain excessively loose (6.2.1d)

of side front fork leg slight oil weeping

slight runout front wheel

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

horn audible level borderline

studs on exhaust sheared but is secure

horn audible level borderline

studs on exhaust sheared but is secure

Drive chain worn to excess (6.2.1e)

Headlamp aim too high (1.6)

Rear Brake locking device missing (3.2.A1e)

Registration plate with character(s) which are not the correct height (6.3.4a)

Registration plate with character(s) which are not the correct width (6.3.4a)

Rear reflector on motorcycle missing (1.4.1)

Drive chain excessively loose (6.2.1d)

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Drive chain excessively loose (6.2.1d)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))