2007 Mazda Bongo

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Windscreen wiper blade defective (3.4 (b) (i))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced cross member (6.1.1 (c) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both D bushes (5.3.4 (a) (i))

Nearside Rear Inner Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Towbar obstructing the registration plate (6.1.6 (f) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Inner Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both D bushes (5.3.4 (a) (i))

Nearside Rear Inner Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Towbar obstructing the registration plate (6.1.6 (f) (i))

Both front tyres perished within the tread face

Corrosion present around both rear spring prescribed areas

Front Inner Brake pad(s) wearing thin pads worn (1.1.13 (a) (ii))

Nearside Front Tyre slightly damaged/cracking or perishing perished in tread grooves (5.2.3 (d) (ii))

Nearside Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing perished in tread grooves (5.2.3 (d) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened inner surface (1.1.14 (a) (ii))

Offside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced wing holed (6.1.1 (c) (i))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre slightly damaged/cracking or perishing perished in tread grooves (5.2.3 (d) (ii))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Tyre slightly damaged/cracking or perishing perished in tread grooves (5.2.3 (d) (ii))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Front Inner Brake pad(s) wearing thin pads worn (1.1.13 (a) (ii))

Nearside Front Tyre slightly damaged/cracking or perishing perished in tread grooves (5.2.3 (d) (ii))

Nearside Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing perished in tread grooves (5.2.3 (d) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened inner surface (1.1.14 (a) (ii))

Offside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced wing holed (6.1.1 (c) (i))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre slightly damaged/cracking or perishing perished in tread grooves (5.2.3 (d) (ii))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Tyre slightly damaged/cracking or perishing perished in tread grooves (5.2.3 (d) (ii))

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

underside corrosion

OSR slight corrosion on chassis

Offside Front tyre wearing on outer edge

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear fog lamp not working (1.3.2b)

OSR slight corrosion on chassis

Offside Front tyre wearing on outer edge

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Inner Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Inner Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

n/s/r tyre perished

o/s/r tyre perished

Nearside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

n/s/r tyre perished

o/s/r tyre perished

Emissions not tested (7.3.A.1)

Nearside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.2.C.1c)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Track rod end ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

front brake application uneven (3.7.B.2)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

emissions near limit

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Nearside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Rear position lamp(s) incorrect colour (1.1.A.3e)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)