2018 Lexmoto Adrenaline 125 Efi

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Indicator tell tale inoperative (4.9.1 (a) (i))

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Offside Front Shock absorber has a light misting of oil (5.3.2 (b))

Rear Lower Suspension pin, bush or joint worn but not resulting in excessive movement linkage (5.3.4 (a) (i))

Steering headbearing has slight free play (2.2.2 (f) (i))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Front Position lamp incorrect colour (4.2.3 (a) (i))

Indicator tell tale inoperative (4.9.1 (a) (i))

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Offside Front Shock absorber has a light misting of oil (5.3.2 (b))

Rear Lower Suspension pin, bush or joint worn but not resulting in excessive movement linkage (5.3.4 (a) (i))

Steering headbearing has slight free play (2.2.2 (f) (i))

Front Indicator tell tale inoperative (4.9.1 (a) (i))

Offside Front Stop lamp switch does not operate in accordance with the requirements poss corroded switch internals (4.3.2 (a) (i))

Front Brake pad(s) contaminated oil from forks on pads (1.1.13 (b))

Nearside Front Shock absorber has a serious fluid leak leaking to excess, as so far has contaminated front brake pads (5.3.2 (b))

Rear Registration plate does not conform to the specified requirements only measures 7" x 5" (should be 9" x 7"), also lettering too small (0.1 (d))

Nearside Rear Drive chain excessively tight, so that it is likely to fail chain too tight, also tension varies so possibly worn uneven (6.1.7 (k) (ii)) DANGEROUS

Offside Rear Brake pad(s) less than 1.0 mm thick pads below minimum limit (1.1.13 (a)) DANGEROUS

Front Indicator tell tale inoperative Indicator repeater or tell tale on dash not working (4.9.1 (a) (i))

Offside Front Stop lamp switch does not operate in accordance with the requirements brake switch operates brake light but not throughout lever travel, light goes on & off, believed to be corroded switch internals (4.3.2 (a) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Rear Brake disc worn, but not excessively slightly distorted (1.1.14 (a) (i))

Rear Lower Suspension ball joint worn, but not excessively (5.3.4 (a) (i))

Drive chain excessively loose (6.1.7 (c) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Rear Brake binding but not excessively (1.2.1 (f))

Rear Brake disc worn, but not excessively slightly distorted (1.1.14 (a) (i))

Rear Lower Suspension ball joint worn, but not excessively (5.3.4 (a) (i))

Drive chain slightly loose (6.1.7 (c) (i))

Rear Upper Shock absorber has a slightly worn bush (5.3.2 (c))

Rear Suspension component pin or bush excessively worn Bottom bracket (5.3.4 (a) (i))

Rear Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Drive chain slightly loose (6.1.7 (c) (i))