1999 Ford F250

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Inner sill has a small rot hole next to step mount but step still secure with other mounts

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

rear load body crossmember rotted but still secure

Front Anti-roll bar pin or bush excessively worn D-bushes (5.3.4 (a) (i))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

front brake discs worn and light corrosion.

rear cross member of load area corroded at each end.

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Exhaust has a minor leak of exhaust gases rear exhaust box blowing under heat shield (6.1.2 (a))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced front chassis (6.1.1 (c) (i))

Nearside Front Upper Vehicle structure is corroded but structural rigidity is not significantly reduced corrosion hole in radiator cross member area (6.1.1 (c) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Nearside Registration plate lamp throwing direct white light to the rear (4.7.1 (a))

Offside Rear Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced chassis (6.1.1 (c) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced corrosion holes in rear bed and bed supports- secure (6.1.1 (c) (i))

Rear fog lamp lens defective which has no effect on emitted light (4.5.1 (b) (i))

both front mount bushes body to chassis starting to split- secure

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Exhaust has a minor leak of exhaust gases rear exhaust box blowing under heat shield (6.1.2 (a))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced front chassis (6.1.1 (c) (i))

Nearside Front Upper Vehicle structure is corroded but structural rigidity is not significantly reduced corrosion hole in radiator cross member area (6.1.1 (c) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Nearside Registration plate lamp throwing direct white light to the rear (4.7.1 (a))

Offside Rear Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced chassis (6.1.1 (c) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced corrosion holes in rear bed and bed supports- secure (6.1.1 (c) (i))

Rear fog lamp lens defective which has no effect on emitted light (4.5.1 (b) (i))

both front mount bushes body to chassis starting to split- secure

Nearside Front Upper Vehicle structure is corroded but structural rigidity is not significantly reduced corrosion hole near radiator front corss member mounting pooint (6.1.1 (c) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced 2nd to rear floor cross member heavily corroded (6.1.1 (c) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced large corrosion hole in 2nd to rear floor cross member (6.1.1 (c) (i))

Offside Rear fog lamp lens defective which has no effect on emitted light (4.5.1 (b) (i))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords outer side wall (5.2.3 (d) (i))

Rear Exhaust has a major leak of exhaust gases large hole in exhaust box (6.1.2 (a))

Nearside Front Upper Vehicle structure is corroded but structural rigidity is not significantly reduced corrosion hole near radiator front corss member mounting pooint (6.1.1 (c) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced 2nd to rear floor cross member heavily corroded (6.1.1 (c) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced large corrosion hole in 2nd to rear floor cross member (6.1.1 (c) (i))

Offside Rear fog lamp lens defective which has no effect on emitted light (4.5.1 (b) (i))

Central Stop lamp not working (1.2.1b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front suspension has excessive play in a upper suspension ball joint left hand (2.5.B.1a)

Nearside rear brake binding left (3.7.B.1)

Nearside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Offside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

exhaust system corroding

slight corrosion on metal brake pipes

exhaust heat shield insecure

o/s door mirror cracked

corrosion on brake pipes

damage to offside mirror

Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Leaf spring fractured (2.4.B.1a)

Offside Registration plate lamp not working (1.1.5c)

corrosion on brake pipes

damage to offside mirror

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front brake disc slightly pitted (3.5.1h)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear Shock absorber has slight external damage to the casing (2.7.2a)

Offside Front brake disc slightly pitted (3.5.1h)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear fog lamp not working (1.3.2b)

Front Brake pad(s) wearing thin (3.5.1g)

centre exhaust clamps corroded/insecure

Front Brake pad(s) wearing thin (3.5.1g)

centre exhaust clamps corroded/insecure