1998 Mitsubishi Canter

Fuel tank slightly loose (6.1.3 (a) (i))

Nearside Front Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Track rod end ball joint has slight play (2.1.3 (b) (i))

Slight movement in kingpin offside front

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Oil leaking excessively from transmission Rear diff (8.4.1 (a) (i))

Parking brake lever ratchet not holding correctly (1.1.6 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Brake pedal wearing smooth (1.1.2 (c))

Brake pipe corroded, covered in grease or other material Various front & Rear (1.1.11 (c))

Oil leak, but not excessive Engine (8.4.1 (a) (i))

Slight corossion to chassis (Nearside)

ALL 4 REAR TYRES CRACKING

CLUTCH SLAVE LEAKING

GENERAL CORROSION

Nearside Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Front Seat belt anchorage prescribed area is excessively corroded Cab floor at rear (5.2.6)

Nearside Obligatory mirror insecure (8.1.1)

Offside Front Seat belt anchorage prescribed area is excessively corroded Cab floor at rear (5.2.6)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Steering system excessively tight (2.2.D.1)

Both offside and nearside seat mountings corroded but seats still secure

Chassis corroded front and rear

Chassis plates seperating offside and nearside (centre /rear)

Surface corrosion of front suspension components

Nearside Axle king pin has excessive play in pin and/or bush adversely affecting the steering (2.5.A.3a)

Nail in nearside rear tyre

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

nearside kingpin deteriorated

steering stiff

Offside Rear Direction indicator not working (1.4.A.2c)

Offside Rear rear brake excessively fluctuating (3.7.B.3)

Offside Rear rear parking (secondary) brake grabbing severely (3.7.B.6b)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Front number plate deteriorated.

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Axle king pin has slight play in pin and/or bush (2.5.A.3a)

offside front tyre low inner edge

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Axle king pin has slight play in pin and/or bush (2.5.A.3a)

nearside front indicator insecure

offside front tyre low inner edge

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust has part of the system excessively deteriorated (7.1.1a)

Exhaust system not adequately supported (7.1.1)

Nearside Front position lamp(s) insecure (1.1.A.3a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too high (1.8)

offside rear bump stop missing

Nearside Front position lamp(s) insecure (1.1.A.3a)

Nearside Stop lamp not working (1.2.1b)

offside rear bump stop missing

nearside front side lamp insecure

offside rear bump stop missing

Offside Headlamp not working on dipped beam (1.7.5a)

nearside front side lamp insecure

offside rear bump stop missing

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)