2014 Kymco Zing

Brake pedal not releasing correctly and functionality of brakes affected (1.1.2 (b) (ii))

Drive chain worn to excess (6.1.7 (c) (i))

Front Outer Direction indicator not working (4.4.1 (a) (ii))

Front Position lamp not working (4.2.1 (a))

Headlamp aim unable to be tested LIGHT LOOSE (4.1.2 (b))

Horn not working (7.7 (a))

Rear reflector missing (4.8.2 (a) (ii))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Drive chain so loose it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Front Inner CLUTCH LEVER BENT

Front Tyre worn close to the legal limit (5.2.3 (e))

Handlebar deformed but serviceable (2.2.1 (c) (i))

NO PASS LIGHT

Rear Shock absorber has a reduced damping effect (5.3.2 (b))

Nearside Front Direction indicator insecure (4.4.1 (c) (i))

Offside Front Direction indicator insecure (4.4.1 (c) (i))

Drive chain slightly loose (6.1.7 (c) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Wheel alignment slightly misaligned (2.4 (a))

fuel tank seal worn

rear sprocket carrier bearing worn

Drive chain slightly loose (6.1.7 (c) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear reflector missing (4.8.2 (a) (ii))

Wheel alignment slightly misaligned (2.4 (a))

fuel tank seal worn

rear sprocket carrier bearing worn

Drive chain excessively tight (6.1.7 (k) (i))

Front Shock absorber has negligible damping effect (5.3.2 (b))

Headlamp aim too high kick up to the right (4.1.2 (a))

Wheel alignment slightly misaligned (2.4 (a))

engine revs up with no throttle input

Exhaust noise is clearly in excess of that emitted by a similar motorcycle fitted with a standard silencer in average condition (8.1.1 (a))

Footrest insecure Both front footrests very loose (6.2.12 (a))

Headlamp aim too low (4.1.2 (a))

Nearside Shock absorber has a serious fluid leak (5.3.2 (b))

Offside Direction indicator not working (4.4.1 (a) (ii))

Rear reflector missing (4.8.2 (a) (ii))

Drive chain worn to excess (6.1.7 (c) (i))

Fuel system component leaking Bottom of carb damp (6.1.3 (b) (i))

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Nearside Rear N/S/R indicator wire rubbing on tyre

Front Headlamp plug wiring chafing and signs of burning