1991 Mazda MX-5

Exhaust has a minor leak of exhaust gases center joint (6.1.2 (a))

Nearside Front Brake hose slightly chafed (1.1.12 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside Front Tyre not fitted in accordance with side wall instructions wrong rotation (5.2.3 (i))

Nearside Rear Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Brake pipe excessively corroded front to rear to brake hose (1.1.11 (c))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength box section (5.3.6 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Exhaust has a minor leak of exhaust gases center joint (6.1.2 (a))

Nearside Front Brake hose slightly chafed (1.1.12 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Front bumper some movement.

Offside Rear brake discs back plate.

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust catalytic converter missing where one was fitted as standard (8.2.2.1 (a))

Exhaust has a major leak of exhaust gases middle joint (6.1.2 (a))

Nearside Front Upper Suspension component insecurely attached ball joint split pin missing (5.3.3 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Lower Suspension component insecurely attached ball joint split pin missing (5.3.3 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner wheel arch (7.1.1 (a) (i))

Offside Seat belt anchorage prescribed area is inadequately repaired outer sill holed full of filler (7.1.1 (a) (i))

Integral body structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired drivers main a pillar fibreglass repair (6.2.2 (d) (ii)) DANGEROUS

Nearside Rear Seat belt anchorage likely to become detached in the event of a collision outer sill inner sill andinner wheel arch excessively corroded and holed (7.1.1 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material rear main corroded (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge wearing on edges (5.2.3 (e))

Offside Front Upper Suspension arm ball joint has slight play slight side ways movement (5.3.4 (a) (i))

Front Bumper insecure (6.1.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Steering column has excessive movement up and down (2.2.2 (a))

Brake servo inoperative (1.1.10 (a) (ii)) DANGEROUS

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

under body suspension and components corroded

Nearside Front Hydraulic brake calliper leaking (1.1.16 (b) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

corrosion various parts of underbody and components

oil leak

outer sills are corroded in places look like filler in parts may go through with heavier tool ok at time of test with corrosion assessment tool

slight corrosion some brake pipes

some damage to bodywork at time of test

Hazard warning lamps inoperative (1.4.B.1b)

Offside Headlamp not working on main beam (1.7.5a)

Offside Rear Suspension arm corroded and seriously weakened (2.4.G.1)

Power steering inoperative (2.3.3a)

Brake fluid warning lamp illuminated (3.6.G.2)

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Nearside Front Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Front Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Front Suspension component mounting prescribed area is excessively corroded chassis (2.4.A.3)

rear exhaust tail pipe missing

water leak from engine

Brake pipe slightly corroded (3.6.B.2c)

Vehicle structure has slight corrosion (6.1.A.1)

Battery insecure (1.9.1)

Nearside Front Body has a sharp edge caused by damage (6.1.C.1)

Nearside Front Headlamp aim too low (1.8)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Headlamp aim too low (1.8)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear fog lamp not working (1.3.2b)

Brake pipe slightly corroded (3.6.B.2c)

Vehicle structure has slight corrosion (6.1.A.1)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear fog lamp not working (1.3.2b)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Headlamp damaged but light output not reduced (1.7.5a)

Offside Front Headlamp deteriorated but light output not reduced (1.7.5a)

offside and nearside brake discs corroding

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front An item not tested (Manual)

Nearside Rear An item not tested (Manual)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside front brake binding (3.7.B.1)

Nearside rear brake binding (3.7.B.1)

Nearside rear brake recording little or no effort (3.7.B.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

rear brake application uneven (3.7.B.2)

Offside Front coil spring fractured (2.4.C.1a) DANGEROUS

Nearside Front brake disc slightly pitted (3.5.1h)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front brake disc slightly pitted (3.5.1h)

Oil leak

nearside front and offside rear tyres perished and split not exposing cord

nearside rear road spring distorted under load

Oil leak

nearside front and offside rear tyres perished

Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

brake disc slightly pitted (3.5.1h)

lower crankshaft pulley-excessive movement