2011 Honda Cbr

Exhaust noisy (8.1.1 (a))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Front Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Offside Handlebar fouling on the fuel tank or bodywork on full lock (2.1.4 (b))

Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii)) DANGEROUS

Exhaust noisy (8.1.1 (a))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Wheel alignment slightly misaligned (2.4 (a))

handle bar alignment differs on lock.

Front Brake grabbing severely (1.2.1 (c))

Rear Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Steering headbearing in such a condition that steering control is adversely affected (2.2.2 (f) (ii)) DANGEROUS

Front Tyre worn close to the legal limit (5.2.3 (e))

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Drive chain excessively tight (6.1.7 (k) (i))

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Drive chain excessively tight (6.1.7 (k) (i))

Steering operation restricted in free movement from lock to lock (2.1.4 (c))

Rear Tyre has ply or cord exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Front gear lever bent ,but can be used

Rear Tyre worn close to the legal limit (4.1.3(ii))

Front Steering headbearing has excessive free play (2.2.2)

Front Brake fluid reservoir fluid level low (3.2.B1d)

Front Wheel alignment slightly misaligned. (2.5.1)

Nearside Front gear lever bent ,but can be used

Rear Tyre worn close to the legal limit (4.1.3(ii))

Stop lamp does not illuminate immediately a brake applies (1.3.1a)