2008 Mazda Bongo

Brake pipe corroded, covered in grease or other material Several (1.1.11 (c))

Suspension component mounting prescribed area is corroded but not considered excessive Several area covered in protector making inspection difficult (5.3.6 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material Several (1.1.11 (c))

Rear Suspension arm corroded but not seriously weakened Panard rod (5.3.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive Several area covered in protector making inspection difficult (5.3.6 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Rear Upper Trailing arm has slight play in a pin/bush Both sides (2.4.G.2)

Suspension component mounting prescribed area is corroded but not considered excessive Several area, but are well sealed making inspection difficult. (2.4.A.3)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Central Exhaust system not adequately supported (7.1.1)

Nearside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale missing (1.3.1b)

Rear Upper Trailing arm has slight play in a pin/bush Both sides (2.4.G.2)

Suspension component mounting prescribed area is corroded but not considered excessive Several area, but are well sealed making inspection difficult. (2.4.A.3)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Suspension component mounting prescribed area is corroded but not considered excessive Several areas of repair in stearing, suspension and seat belt prescribed areas difficult to examine due to the amount of sealer applied. (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive Several front and rear (2.4.A.3)

Parking brake: efficiency below requirements (3.7.C.1b)

Nearside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Suspension component mounting prescribed area is corroded but not considered excessive Several areas of repair in stearing, suspension and seat belt prescribed areas difficult to examine due to the amount of sealer applied. (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive Several front and rear (2.4.A.3)

Front Brake pad(s) wearing thin (3.5.1g)

Front position lamp(s) incorrect colour (1.1.A.3e)

Nearside Inner Front Brake pipe slightly corroded (3.6.B.2c)

O/S/F Inner Sill Correded But Not Near Seat Belt, Drivers Seat Or Suspension

Offside Rear Wheel nut(s) missing (4.2.A.1e)

Offside Stop lamp not working (1.2.1b)

Oil leak

Parking brake lever has little reserve travel (3.1.6b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Inner Front Brake pipe slightly corroded (3.6.B.2c)

O/S/F Inner Sill Correded But Not Near Seat Belt, Drivers Seat Or Suspension

Oil leak

Parking brake lever has little reserve travel (3.1.6b)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Inner Front Brake pipe slightly corroded (3.6.B.2c)

Offside Inner Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Stop lamp not working (1.2.1b)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Radius arm has slight play in a ball joint (2.4.G.2)

Offside Radius arm has slight play in a ball joint (2.4.G.2)

both front tyres just above limit

both front wheels binding slightly

both rear tyres just above limit

exhaust corroded

front brakepads wearing thin

rear brakepads wearing thin

rear discs slightly worn and corroded

slight judder at front brakes

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Horn not working (1.6.2a)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Parking brake lever has no reserve travel (3.1.6b)

Rear Rear fog lamp missing (1.3.2a)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)

front discs slighly worn

front pads wearing thin

rear discs slightly worn

rear pads wearing thin

slight juder at front brakes

slight play in steering raqck bushes