2009 Mazda Bongo

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Central Front Upper Integral body structure is deformed and structural rigidity is significantly reduced cross member hold (6.1.1 (a) (i))

Front Registration plate missing (0.1 (a))

Nearside Front Body panel corroded and likely to cause injury bonnet holed sharp edges (6.2.1 (a) (i))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Outer Integral body structure is deformed and structural rigidity is significantly reduced sill hold (6.1.1 (a) (i))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner wheel arch holed (6.2.2 (d) (i))

Nearside Rear Outer Body panel corroded and likely to cause injury wheel arch sharp edges (6.2.1 (a) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Upper Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting floor end (6.2.2 (d) (i))

Offside Front Body panel corroded and likely to cause injury door sharp edges (6.2.1 (a) (i))

Offside Front Brake disc significantly and obviously worn inner face (1.1.14 (a) (i))

Offside Outer Integral body structure is deformed and structural rigidity is significantly reduced sill hold (6.1.1 (a) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting under wheel arch holed (6.2.2 (d) (i))

Offside Rear Outer Body panel corroded and likely to cause injury wheel arch sharp edges (6.2.1 (a) (i))

Offside Rear Upper Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting floor end (6.2.2 (d) (i))

Rear Upper Seat belt anchorage prescribed area strength or continuity significantly reduced cross member holed (7.1.1 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm on edges (5.2.3 (e)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick inner pad (1.1.13 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm on edges (5.2.3 (e)) DANGEROUS

Central Rear Upper Oil leak, but not excessive (8.4.1 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Integral body structure is deformed but structural rigidity is not significantly reduced all over under body corroded (6.1.1 (a) (i))

Integral body structure is deformed but structural rigidity is not significantly reduced all over upper body corroded (6.1.1 (a) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Upper Anti-roll bar pin or bush worn but not resulting in excessive movement d bush (5.3.4 (a) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Windscreen wiper blade defective (3.4 (b) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill/chasiss (5.3.6 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Central Rear Upper Stop lamp(s) light intensity obviously reduced (4.3.3 (a) (i))

Front Lower Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement arm front bush (5.3.4 (a) (i))

Nearside Rear Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Outer Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Outer Seat belt anchorage prescribed area is corroded but not considered excessive arch (7.1.1 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement arm front bush (5.3.4 (a) (i))

Offside Rear Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Outer Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Outer Seat belt anchorage prescribed area is corroded but not considered excessive arch (7.1.1 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Oil leak, but not excessive at engine (8.4.1 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill holed (5.3.6 (a) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Rear Inner Tyre tread depth below requirements of 1.6mm edge bold (5.2.3 (e)) DANGEROUS

Offside Rear Inner Tyre tread depth below requirements of 1.6mm edge bold (5.2.3 (e)) DANGEROUS

Central Rear Upper Stop lamp(s) light intensity obviously reduced (4.3.3 (a) (i))

Front Lower Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement arm front bush (5.3.4 (a) (i))

Nearside Rear Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Outer Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Outer Seat belt anchorage prescribed area is corroded but not considered excessive arch (7.1.1 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement arm front bush (5.3.4 (a) (i))

Offside Rear Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Outer Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Outer Seat belt anchorage prescribed area is corroded but not considered excessive arch (7.1.1 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Oil leak, but not excessive at engine (8.4.1 (a) (i))

Body has slight corrosion under body (6.1.B.2)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Lower Suspension arm corroded but not seriously weakened (2.4.G.1)

Nearside Inner Body has slight corrosion sill holed (6.1.B.2)

Offside Front Lower Suspension arm corroded but not seriously weakened (2.4.G.1)

Offside Rear Tyre worn close to the legal limit on edges (4.1.E.1)

Rear pads obscured unable to fully test

Upper Body has slight corrosion (6.1.B.2)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill holed (6.1.B.2)

Nearside Rear Body has a projection caused by damage bumper (6.1.C.1)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Body has slight corrosion under body (6.1.B.2)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Lower Suspension arm corroded but not seriously weakened (2.4.G.1)

Nearside Inner Body has slight corrosion sill holed (6.1.B.2)

Offside Front Lower Suspension arm corroded but not seriously weakened (2.4.G.1)

Offside Rear Tyre worn close to the legal limit on edges (4.1.E.1)

Rear pads obscured unable to fully test

Upper Body has slight corrosion (6.1.B.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Exhaust has a major leak of exhaust gases front to rear (7.1.2)

Front Suspension component mounting prescribed area is excessively corroded crossmember (2.4.A.3)

Nearside Front Inner Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Rear Outer Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Rear Outer Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Rear fog lamp not working (1.3.2b)

Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)