2010 Mazda Bongo

Nearside Front Upper Macpherson strut mounting damaged but not seriously weakened noisy (5.3.3 (b) (i))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Upper Macpherson strut mounting damaged but not seriously weakened noisy (5.3.3 (b) (i))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Central Stop lamp(s) with a multiple light source more than 1/2 not functioning (4.3.1 (a) (ii))

Front Service brake excessively fluctuating (1.2.1 (e))

Headlamp aim projected beam image is obviously incorrect both (4.1.2 (c))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Upper Suspension component mounting prescribed area is corroded but not considered excessive bothsides (5.3.6 (a) (i))

Inner and outersills corroded

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear wheel arch corroded

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Rear fog lamp does not emit a steady red light (4.5.4 (a))

Windscreen washer not working (3.5 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

under van has been under sealed

Emissions not tested (8.2.1.2 (d))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

under van has been under sealed

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emits excessive dense blue smoke during acceleration (7.3.A.2c)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Rear fog lamp emits a light other than red (1.3.2e)

Nearside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

High level brake light not working

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Rear fog lamp emits a light other than red (1.3.2e)

High level brake light not working

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside front tyre worn on outer edge

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Coolant leak from engine area

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear exhaust flexi gauze damaged

Unable to clearly see front to rear brake pipes

Coolant leak from engine area

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear exhaust flexi gauze damaged

Unable to clearly see front to rear brake pipes

Nearside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside front wiper slightly smears screen

Offside front wiper slightly smears screen

Both headlamps cloudy

Both wipers smear screen

Unable to clearly see front to rear brake pipes due to undershield

Exhaust has part of the system slightly deteriorated (7.1.1a)

Headlamp aim too low (1.8)

Horn not working (1.6.2a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Exhaust has part of the system slightly deteriorated (7.1.1a)