1997 Mazda 121

Nearside Front Anti-roll bar synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

chassis rusting

inner and outer sills rusting

rear axel rusting

Front Anti-roll bar synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

inner and outer sills rusting

rear axel rusting

rear chassis rusting

Front Anti-roll bar synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

inner and outer sills and axel rusting

Offside Outer Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

both rear inner sills and axle beam rusting and weak

Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

chassis starting to rust to places

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

offside and nearside floor to sills getting corroded

offside and nearside inner sill areas getting corroded

Front registration plate delaminated (6.3.1d)

Offside Front Obligatory mirror missing (8.1.1)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Brake pipe excessively corroded (3.6.B.2c)

Macpherson strut has excessive movement in the upper support bearing assembly (2.5.B.1b)

Offside Front Lower Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Centre Exhaust has part of the system slightly deteriorated (7.1.1a)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Wheel bolt(s) missing (4.2.A.1e)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear wheel bearing rough when rotated (2.6.1)