1982 Ford Escort

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material to flexi (1.1.11 (c))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Macpherson strut insecurely attached (5.3.3 (a) (i))

Offside Rear Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Headlamp light intensity severely reduced (4.1.4 (a))

Offside Front Lower Floor excessively deteriorated (6.2.4 (a) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Steering rack gaiter damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Rear fog lamp not working (1.3.2b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

off side front sill end/ inner arch bottom corroded but not in prescribed area

signs of both rear shockers weakening. o k at test time

small pin hole in rear corroded part of exhaust system. not excessive at test time

Nearside Front Headlamp not working on main beam (1.7.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front position lamp(s) not working (1.1.A.3b)

Parking brake: efficiency below requirements (3.7.B.7)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

off side front brake pads worn to approx 2mm material left BORDERLINE PASS

off side front sill end/ inner arch bottom corroded but not in prescribed area

signs of both rear shockers weakening. o k at test time

small pin hole in rear corroded part of exhaust system. not excessive at test time

both near side and off side front and rear shockers showing signs of weakening on bounce test .NO leaks at time of test

Exhaust has a major leak of exhaust gases (7.1.2)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

both near side and off side front and rear shockers showing signs of weakening on bounce test.NO leaks and seem O K at time of test