1981 Rover 3500

Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Oil leak ()

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Oil leak ()

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Nearside Rear Inner Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Inner Tyre worn close to the legal limit (4.1.E.1)

Front Service brake application uneven across the axle (3.7.D.2b)

Nearside Rear Parking brake recording little or no effort (3.7.D.3a)

Brake pedal repaired, but not inappropriately (3.3.A.6)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear coil spring corroded (2.4.C.1b)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Offside Rear position lamp(s) not working (1.1.A.3b)

Power steering pump leaking from a failed joint (2.3.3b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear coil spring corroded (2.4.C.1b)

Brake pedal anti-slip provision missing (3.3.A.1b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Shock absorber casing corroded externally so the unit does not function (2.7.2a)

Oil leak

Nearside Inner Rear Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Steering rack gaiter split (2.2.D.2d)

Offside Inner Rear Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Rear Shock absorber has a slightly worn bush (2.7.4)